Impact driver
Used daily- insert and remove screws. Add attatchments to remove sockets and nuts quickly. Comes with charger, battery, and bag.
9 and 1 screwdriver
Comes with Phillips and flat head bits. Remove the bits to use as a nut driver to tighten bolts such as heating element bolts in a henny
Tape measure
Common tool to measure items throughout the store
Socket set
Remove bolts and nuts. Used throughout the store and in equipment
T-handle allen key set
Ball end and the T-handle make this set nice to remove allen screws at different angles while applying good torque. Used often in henny repair work/ preventive maintenance. Set comes wilth the following sizes 3/32, 7/64, 1/8, 9/64, 5/32, 3/16, 7/32, 1/4, 5/16, 3/8
8" Pipe wrench
Remove smaller pipes and components with ease
Channel locks
6.5, 9.5, and 12 inch channel locks to help remove pipes, remove compression fittings, or hold a piece of metal
Adjustable wrench set
Remove and tighten nuts and compression fittings. Used often on the henny
8" Needle nose pliers
Get into hard to reach places with needle nose pliers
Heat gun
Used to reseal fridge gaskets
water key
Turn on/ off outside water spigot
24" level
Used to level items such as shelves on the wall or use as a sraight edge
Hammer
Used to hammer in nails or setting pins on equipment
Caulk gun
Caulk gun used to lay caulking
10" locking pliers
Helps to hold bolts and remove stubborn pipes
Clamp meter
Used to test voltage, temp, amps, and continuity
Wire crimpers
Crimp connections on electrical wire
Wire strippers
Used to cut and strip wire insulation
6" bit extension
Used with an impact or drill to get to hard to reach places. Especially helpful when removing the pump cover on a fryer
90 degree drill attachment
Used to remove screws and bolts in hard to reach places. Great to remove casters on the bottom of fridges when combined with a nut driver and an impact.
12" socket extension
Used with a socket wrench to reach hard to reach places like behind the control board
Crows feet flare set
Used to remove nuts. Useful when replacing a high limit in a henny. Comes in a set with both standard and metric sizes
18" Pipe wrench
Remove larger pipes and components such as the drain valve on the henny
Bolt extractor
Remove stripped bolts
Nut driver set
drive nuts and bolts into place with ease
Torx bit set
Used to remove security screws. Used on the toto plumbing fixtures to replace batteries
Pin punch set
Used to remove pins from equipment. Uses could be to remove lid latch pin, lid hinge pin, or knob pin on the henny
Garland service wrench
Use two wrenches when performing gap calibration
Platen leveling tool
Used when performing gap calibration on garland grill